|
![]() |
#1 |
Member
Join Date: May 2014
Location: E TN
Posts: 447
Likes: 14
Liked 109 Times in 63 Posts
|
![]()
Other discussion about MC's and the mention of a MC with 60/40 bias.
Someone explain to me how the MC can have 60/40 bias when the bore in the MC is the same size for both pistons/ports. I know GM used some step bore MC's where the pistons are different sizes for each port which makes sense using hydraulic principles where the same pressure is applied to 2 different size pistons results in different pressure out of the ports. |
![]() |
![]() |
![]() |
#2 |
Member
Join Date: Aug 2010
Location: CT
Posts: 410
Likes: 1,325
Liked 288 Times in 123 Posts
|
![]()
The positioning of the "cups" are staggered, which changes the timing of the application of pressure
__________________
Phil Molski PMR Performance S/C 1623 |
![]() |
![]() |
Liked |
![]() |
#3 |
Member
Join Date: May 2014
Location: E TN
Posts: 447
Likes: 14
Liked 109 Times in 63 Posts
|
![]() |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Aug 2010
Location: CT
Posts: 410
Likes: 1,325
Liked 288 Times in 123 Posts
|
![]()
They will be different, due to the compression on one side versus the other - start compressing later would result in lower pressure.
__________________
Phil Molski PMR Performance S/C 1623 |
![]() |
![]() |
![]() |
#5 |
VIP Member
Join Date: Nov 2007
Location: New Jersey
Posts: 1,832
Likes: 79
Liked 466 Times in 217 Posts
|
![]()
Pressure can only be increased by changing the pedal ratio or by decreasing the master cylinder bore.
|
![]() |
![]() |
![]() |
|
|