|
![]() |
#11 |
VIP Member
Join Date: Dec 2001
Location: phoenix
Posts: 1,451
Likes: 56
Liked 690 Times in 274 Posts
|
![]()
Input speed sensor sounds very promising
|
![]() |
![]() |
![]() |
#12 |
VIP Member
Join Date: May 2006
Location: Murfreesboro TN
Posts: 4,968
Likes: 1,118
Liked 1,217 Times in 312 Posts
|
![]()
A stand alone TCU is a waste. There's no reason to need one or go through the hassle.The stock stuff works fine, there's several million dollars worth of R&D behind them for reliability. Adding some stand alone controller requires more wiring harness and adapting/interfacing that just adds complexity, and does not guarantee a solution.
It's more likely to be a wiring harness problem than an ECU. The wiring diagram for your truck can be found online, probably for free. There are two ATSG manuals that are good for that transmission, one is a dedicated rebuild manual, the other is a manual that covers it and the 4L60E, and includes the electronic/electrical diagnosis.
__________________
Alan Roehrich 212A G/S |
![]() |
![]() |
![]() |
#13 |
Member
Join Date: May 2006
Location: Southwest Florida
Posts: 251
Likes: 25
Liked 35 Times in 25 Posts
|
![]()
i was a GM service manager for many years, when we would see problems like this we usually found that the pin tension on the harness was not adequate for a proper connection. It is very important that you probe the terminals with the proper pin connectors, if someone used a test light or an ohm meter to check for continuity than they may have spread the terminals just enough to make for a poor connection. Make sure your shop has the proper tools to diagnosis this concern.
__________________
Mark Ruset 2048 STK |
![]() |
![]() |
Liked |
![]() |
#14 | |
Junior Member
Join Date: May 2014
Location: Wilmington NC
Posts: 87
Likes: 128
Liked 45 Times in 16 Posts
|
![]() Quote:
You make a great point on the TCU. I'll research the manuals you've referenced. Waiting on rain to pass here so I can get back under it and swap the input speed sensor. Thinking about swapping the neutral safety switch as well. I found a new one yesterday that had been picked up for another truck that has been sold. Nice to find stuff I had long forgotten about. As long as it's the same part from 95 to 98 anyways. I'm optimistic. I'll pull up wiring diagrams as well. Thanks for the info.
__________________
William Kilduff 1970 Barracuda (still under construction, indefinitely) 1968 Camaro SS/C |
|
![]() |
![]() |
![]() |
#15 | |
Junior Member
Join Date: May 2014
Location: Wilmington NC
Posts: 87
Likes: 128
Liked 45 Times in 16 Posts
|
![]() Quote:
I'll certainly keep this in mind. Thanks.
__________________
William Kilduff 1970 Barracuda (still under construction, indefinitely) 1968 Camaro SS/C |
|
![]() |
![]() |
![]() |
|
|