|
08-03-2022, 08:01 AM | #1 |
Senior Member
Join Date: Apr 2008
Posts: 852
Likes: 1
Liked 472 Times in 115 Posts
|
Fast EFI 2.051 internal datalogging issue/setup
Trucks ECU got used to tune the dart, now its starting to datalog too early.
Truck uses a brake pressure switch for the two step. Two step RPM is controlled by ignition box ie msd, we don't use fasts internal two step. Now its starting to datalog the second the brake pressure switch is tripped(burnout) I can only get it to datalog with it setup with manual trigger, and PA enable. Could it be the firmware? I think you should be able to seupt the internal datalogger without a switch ie set trigger point to 95% TPS, and arm it with PA enable, Aux 7 is a switch. Thanks Eric
__________________
Eric Merryfield 1883 STK |
08-04-2022, 11:34 AM | #2 |
Member
Join Date: Mar 2003
Location: MA.
Posts: 277
Likes: 138
Liked 145 Times in 38 Posts
|
Re: Fast EFI 2.051 internal datalogging issue/setup
Eric Are you Pulsing power or ground on the switch ? Aux 7 should be on a momentary switch to arm the system and set TPS to trigger.
|
08-04-2022, 01:53 PM | #3 | |
Senior Member
Join Date: Nov 2003
Location: Donaldsonville, LA
Posts: 969
Likes: 8
Liked 184 Times in 63 Posts
|
Re: Fast EFI 2.051 internal datalogging issue/setup
Quote:
__________________
Jimmy "Cooter" Hidalgo, Jr. 4865 E/SA '04 GTO 4865 SS/GA '99 Firebird |
|
|
|