|
05-07-2016, 08:36 AM | #1 |
Junior Member
Join Date: Nov 2008
Posts: 23
Likes: 0
Liked 0 Times in 0 Posts
|
Metric 200 Pump Pressure
I'm getting around 200 psi at idle in 1st, 2nd, and 3rd gear and the pressure goes up to 250 off idle. Is that too high?
I had a converter give up on me last fall and I'm trying to figure if it was too much line pressure, or the 1000+ runs that were on the converter? Bill Lent O/SA 3158 |
05-07-2016, 10:22 AM | #2 |
Senior Member
Join Date: Feb 2002
Location: Southeast Michigan
Posts: 891
Likes: 64
Liked 227 Times in 106 Posts
|
Re: Metric 200 Pump Pressure
Converter pressure is about 1/2 of line pressure . If the converter failed because it ballooned, then usually you will see damage on the crank thrust bearing . If the converter has ballooning plates, and is furnace brazed, it should be able to handle over 150 psi @ 7000 rpm .
|
|
|