|
![]() |
#1 |
Junior Member
Join Date: May 2016
Posts: 2
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
In a powerglide if the stater support spins will it still produce enough line pressure to make a person think the pump is good to go? On the starting line motor won't go past 4000. Had my converter cut open but found nothing wrong. My converter man says I have a problem somewhere else.
|
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Jan 2003
Location: Allentown,PA
Posts: 2,443
Likes: 804
Liked 722 Times in 211 Posts
|
![]()
The transmission will still function , The tube has no bearing on the pump pressure , but with the converter feed restricted the stall will be off and trans temp will skyrocket due to the cooling circuit being blocked .
It should be easy to see the hole alignment of the stator tube when you disassemble the pump. The tube ,stock or replacement should always be pinned with a set screw , but even that is not fool proof .
__________________
Tom Goldman 1500 SG , 1506 STK |
![]() |
![]() |
![]() |
#3 |
Junior Member
Join Date: May 2016
Posts: 2
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
Thanks for the reply. The stater was pinned with a set screw and since the trans had 210 psi idling in low gear I figured it had to be the converter. Will check to see if the pin is still in place.
|
![]() |
![]() |
![]() |
|
|