Cam question/help

greg fulk · 05-08-2011, 06:36 PM

I bought a 305 out of an 81 Z-28 the cam that was in it was a Crane part # 11-41-84 grind # ssh-310-nc I can't find any info on it.....anyone know what it is?

Bob Mulry · 05-08-2011, 07:06 PM

Hi,

I found this on the Nasty Z28 website....

I don't know if info is correct????????????

Crane
114051 SSH-310-NC, hydraulic, rough idle, good midrange hp
Intake Open-Close BTDC-ABDC 40-90
Exhaust Open-Close BBDC-ATDC 88-42
Degrees Advertised Duration Int. 310 Exh. 310
Degrees Duration @ .050 Cam Lift Int. 236 Exh. 236
Running Clearance Hot Int .000 Exh. .000
Gross Valve Lift Int. .485 Exh. .485
RPM Range min 3800 max 6800 valve float 7000

Good luck,
Bob

greg fulk · 05-08-2011, 08:11 PM

Humm I just check lobe lift it was .314 that would make it 470 with a 1.5 rocker. Thanks for the info Bob

05-08-2011, 06:36 PM	#1
greg fulk VIP Member Join Date: Jan 2003 Location: jackson Posts: 1,165 Likes: 0 Liked 5 Times in 3 Posts	Cam question/help I bought a 305 out of an 81 Z-28 the cam that was in it was a Crane part # 11-41-84 grind # ssh-310-nc I can't find any info on it.....anyone know what it is? __________________ Greg Fulk 308 308X P/SA "ALL AMERICAN"

05-08-2011, 07:06 PM	#2
Bob Mulry VIP Member Join Date: Apr 2002 Location: Coarsegold, CA Posts: 1,017 Likes: 57 Liked 321 Times in 101 Posts	Re: Cam question/help Hi, I found this on the Nasty Z28 website.... I don't know if info is correct???????????? Crane 114051 SSH-310-NC, hydraulic, rough idle, good midrange hp Intake Open-Close BTDC-ABDC 40-90 Exhaust Open-Close BBDC-ATDC 88-42 Degrees Advertised Duration Int. 310 Exh. 310 Degrees Duration @ .050 Cam Lift Int. 236 Exh. 236 Running Clearance Hot Int .000 Exh. .000 Gross Valve Lift Int. .485 Exh. .485 RPM Range min 3800 max 6800 valve float 7000 Good luck, Bob __________________ Bob Mulry 7516 STK A & M Motorsports

05-08-2011, 08:11 PM	#3
greg fulk VIP Member Join Date: Jan 2003 Location: jackson Posts: 1,165 Likes: 0 Liked 5 Times in 3 Posts	Re: Cam question/help Humm I just check lobe lift it was .314 that would make it 470 with a 1.5 rocker. Thanks for the info Bob __________________ Greg Fulk 308 308X P/SA "ALL AMERICAN"