SBC Small Jnl ground to Honda pin size

Kingpen · 07-26-2010, 05:25 PM

was wondering since the new rules on rods in S/S,has anyone had any luck ,or issues,with taking a GM small Journal crank down to the honda rod jnl size?Ive done it many times going from 2.100 to 2.0" but will it work on the 2" pin down to the 1.880?my concerns are "moving" the oil hole over too far, or just making the crank weak,or what?????any comments good & bad............thanks Vic Penrod

07-26-2010, 05:25 PM	#1
Kingpen Member Join Date: Feb 2006 Location: sooner state Posts: 105 Likes: 3 Liked 64 Times in 22 Posts	SBC Small Jnl ground to Honda pin size was wondering since the new rules on rods in S/S,has anyone had any luck ,or issues,with taking a GM small Journal crank down to the honda rod jnl size?Ive done it many times going from 2.100 to 2.0" but will it work on the 2" pin down to the 1.880?my concerns are "moving" the oil hole over too far, or just making the crank weak,or what?????any comments good & bad............thanks Vic Penrod

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode