Metric 200 Transmission Shop

Alan Roehrich · 01-28-2025, 08:20 PM

Quote:

Originally Posted by Rich Biebel

On a similar note

Where to buy a Metric converter for a small block stocker

Seems like things change over time with some of these suppliers

It would be wise to convert to the turbo (350/400) input, pump gear, and stator shaft if you're buying a new converter. Broadens your selection infinitely. ATI makes a good converter.

Rich Biebel · 01-28-2025, 09:05 PM

My only current trans has the Metric input
It was gone thru in September by Miranian.
I have been using an Ultimate converter but may need to buy another
ATI was always where I would go to in the past but I was not sure if they are still building good converters.

In the future I?d sure like to have a Sepanek trans built.

01-28-2025, 09:05 PM	#2
Rich Biebel VIP Member Join Date: Jun 2007 Location: Northern New Jersey suburbs Posts: 2,320 Likes: 25 Liked 557 Times in 217 Posts	Re: Metric 200 Transmission Shop My only current trans has the Metric input It was gone thru in September by Miranian. I have been using an Ultimate converter but may need to buy another ATI was always where I would go to in the past but I was not sure if they are still building good converters. In the future I?d sure like to have a Sepanek trans built. __________________ Rich Biebel S/C 1479 Stock 147R

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode