Tips on filling Exhaust Crossover

[Dwight Southerland]

I have used pure plaster of paris (not the kind with silicon in it) with success. Just be sure there are no bubbles in it. The heat from the engine exhaust fires it like in a kiln. Harder than heck to get out after its been run a while.

[Ed Wright]

Originally Posted by Dwight Southerland

I have used pure plaster of paris (not the kind with silicon in it) with success. Just be sure there are no bubbles in it. The heat from the engine exhaust fires it like in a kiln. Harder than heck to get out after its been run a while.

Hmm, first I heard about that.

[Mark Yacavone]

I still use aluminum and a torch, but I don't fill it from the port side anymore..Too much room for error and extra work.
Instead I make little tin or aluminum tabs that are the shape of the passage, with a little tail on them ,which I prop up against a bolt stuck down in the valve guide.
I melt more than enough aluminum, skim, and pour it down in with the intake side horizontal, leaving it a little high. I then smack it with a hammer a few times while it's still warm. Grind it flush with a 40 grit soft disc and some cutting grease.
Pull the tabs and you're done.

I've been told by one of the best in the business that leaving the fill recessed back just a little, doesn't hurt the flow at all.

[Mike Taylor 3601]

I started using zinc years ago when a customer brought in some he had bought from Mondello,I buy mine half price of what Mondello got for it,have never had any of the zinc disappear ,burn out or erode or whatever you want to call it. I may switch to aluminum, because I always have barrel full of old pistons.
Do you just use plain old cast piston ?
Mike Taylor 3601

[Glenn Briglio]

Originally Posted by Mike Taylor 3601

I started using zinc years ago when a customer brought in some he had bought from Mondello,I buy mine half price of what Mondello got for it,have never had any of the zinc disappear ,burn out or erode or whatever you want to call it. I may switch to aluminum, because I always have barrel full of old pistons.
Do you just use plain old cast piston ?
Mike Taylor 3601

Use forged pistons. Some cast pistons have a steel insert in pin area.

[Tom Goldman]

I've poured dozens of AMC heads over the years.
I melt old cast pistons in a cast iron fry pan over my turkey fryer burner .
the pan is small enough to handle the amount of aluminum you will need.
You must skim the dross off the top of the aluminum before pouring.
As far as prepping the head , the crossover port must be free of carbon to ensure proper filling.
I use furnace cement to block the port side for the fill, making sure its in the hole a little ,per the rules.
You can get a small tub of the cement at any hardware store ,and its relatively
easy to remove when your done .
It also helps to warm the head before the pour. ....I usually get them up to 225 deg. before I pour....This helps prevent shrinkage due to the rapid heat transfer to the head.

[B/S 428]

Is this legal in stock? the way I read it, you can fill the intake manifold port but not the head. Brian 627 stk