Jerico 5-speed LONG-shifter

SSJ343 · 07-14-2014, 02:55 PM

Update. It seems that it will stuck in vertical slot. Vertical slot is .440 wide and the shaft is .437. Only thing, that keeps two halves of shifter inline is the two bolts mentioned in Seans reply. These bolts are fully threaded and halves can easily move more than .003 clearance allows.

We widened this lower vertical slot to .452 (same measure as upper vertical slot is!).

Bolts were replaced with ones, that have straight portion above thread and they seems to force shifter halves in line. We will see if it works next weekend. On table it seems to work fine.

This is brand new equipment and has less than 15 runs on. It has stuck 3 times now.

Thank you all about comments and messages.

07-14-2014, 02:55 PM	#4
SSJ343 Junior Member Join Date: Jan 2009 Location: Finland Posts: 12 Likes: 0 Liked 0 Times in 0 Posts	Re: Jerico 5-speed JERICO-shifter Update. It seems that it will stuck in vertical slot. Vertical slot is .440 wide and the shaft is .437. Only thing, that keeps two halves of shifter inline is the two bolts mentioned in Seans reply. These bolts are fully threaded and halves can easily move more than .003 clearance allows. We widened this lower vertical slot to .452 (same measure as upper vertical slot is!). Bolts were replaced with ones, that have straight portion above thread and they seems to force shifter halves in line. We will see if it works next weekend. On table it seems to work fine. This is brand new equipment and has less than 15 runs on. It has stuck 3 times now. Thank you all about comments and messages. Last edited by SSJ343; 07-25-2014 at 03:43 AM. Reason: Typo

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode