jerico input shaft sensor

Dave Casey · 06-24-2012, 01:44 PM

Search here in the tech section and you will find it i believe, you don't need the 1:1 if your data system can apply a ratio to the graph, which some can I am told. just apply the head set ratio and put the sensor on the counter shaft. The problem is that the bellhousings in stock are not as deep as let say pro stock and they can get the sensor in there easily. Last I knew they used sensors on the input in pro stock,

06-24-2012, 01:44 PM	#5
Dave Casey VIP Member Join Date: Dec 2002 Location: Hampden, MA Posts: 1,198 Likes: 233 Liked 769 Times in 162 Posts	Re: jerico input shaft sensor Search here in the tech section and you will find it i believe, you don't need the 1:1 if your data system can apply a ratio to the graph, which some can I am told. just apply the head set ratio and put the sensor on the counter shaft. The problem is that the bellhousings in stock are not as deep as let say pro stock and they can get the sensor in there easily. Last I knew they used sensors on the input in pro stock, __________________ Dave Casey 1330 STK

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode