|
05-16-2012, 07:17 PM | #1 |
Member
Join Date: May 2009
Posts: 148
Likes: 4
Liked 10 Times in 6 Posts
|
68 Camaro switch panel question
I'm looking for a switch panel that fits the hole in the factory center trim panel where the heater controls were installed. Does anyone know one that works reasonably well? Thanks for any help.
|
05-16-2012, 10:49 PM | #2 |
Member
Join Date: May 2006
Location: Southwest Florida
Posts: 251
Likes: 25
Liked 35 Times in 25 Posts
|
Re: 68 Camaro switch panel question
Dana I fabricated my own switch panel for my 68 Camaro. I used a piece of aluminum stock and mounted it where the radio was installed, I used a nut and bolt with a large fender washer, it was secured through the hole for the on-off knob and the tunning knob. It is very simple and very neat.
__________________
Mark Ruset 2048 STK |
05-17-2012, 03:05 PM | #3 |
Junior Member
Join Date: Oct 2007
Posts: 10
Likes: 0
Liked 0 Times in 0 Posts
|
Re: 68 Camaro switch panel question
So you don't have to have the factory pannel in there with the heater controls or is this not a stock/SS car?
|
05-17-2012, 08:32 PM | #4 |
Senior Member
Join Date: Feb 2009
Posts: 934
Likes: 358
Liked 167 Times in 77 Posts
|
Re: 68 Camaro switch panel question
we ran the ARC (autorod.net) #3100 right in '67 camaro heater control panel. worked/fit/looked great...nice piece and racer friendly.
|
Thread Tools | |
Display Modes | |
|
|