head cc

X-TECH MAN · 11-29-2010, 07:42 PM

Its been awhile but I believe I cut 6 thou per CC on the low comp. open type chamber of a 441/993 type head and 5.5 thou per cc on the higher comp (461/462/etc.) heads. Sneak up on it as you cant put the material back on after its cut. Even if you have to take them back to be cut some more and spend a little more $$$ after rechecking depending on how close you want to get. Be sure to use a CERTIFIED Burette and colored alcohol. Its cheaper than preping a new set of heads and better than sinking and/or facing the valves.
Rich...are your sure about cutting .0065 per CC? I dont remember cutting that much per CC???? I could be wrong ! Im old.

11-29-2010, 07:42 PM	#5
X-TECH MAN Banned Join Date: Dec 2007 Location: Lake Placid, Florida Posts: 3,203 Likes: 1,047 Liked 235 Times in 110 Posts	Re: head cc Its been awhile but I believe I cut 6 thou per CC on the low comp. open type chamber of a 441/993 type head and 5.5 thou per cc on the higher comp (461/462/etc.) heads. Sneak up on it as you cant put the material back on after its cut. Even if you have to take them back to be cut some more and spend a little more $$$ after rechecking depending on how close you want to get. Be sure to use a CERTIFIED Burette and colored alcohol. Its cheaper than preping a new set of heads and better than sinking and/or facing the valves. Rich...are your sure about cutting .0065 per CC? I dont remember cutting that much per CC???? I could be wrong ! Im old. Last edited by X-TECH MAN; 11-29-2010 at 07:52 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode