Hipsters 350t transbrake?????

Tom Goldman · 03-29-2010, 10:04 PM

Make sure yu have a full 12 volts when the coil is energized. ...Make sure your ground is good. ,Don't ground the solenoid to the trans case ,use a good chassis ground.........On the Hipster brake you usually have to grind off a small ammount of the end of the modulator valve . ...If too much was removed the valve will leak when line pressure increases.......Check the solenoid first....Tom

03-29-2010, 10:04 PM	#1
Tom Goldman VIP Member Join Date: Jan 2003 Location: Allentown,PA Posts: 2,476 Likes: 887 Liked 866 Times in 235 Posts	Re: Hipsters 350t transbrake????? Make sure yu have a full 12 volts when the coil is energized. ...Make sure your ground is good. ,Don't ground the solenoid to the trans case ,use a good chassis ground.........On the Hipster brake you usually have to grind off a small ammount of the end of the modulator valve . ...If too much was removed the valve will leak when line pressure increases.......Check the solenoid first....Tom __________________ Tom Goldman 1500 SG , 1506 STK

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode