|
|
03-20-2010, 06:58 AM
|
#22 |
|
VIP Member
Join Date: Jun 2007
Location: Northern New Jersey suburbs
Posts: 2,320
Likes: 25
Liked 557 Times in 217 Posts
|
Re: Mixing bearings for clearance
There is no offset on a small or big block chevy rod. Pin hole and crank pin holes are on center......
I can't think of any common engines that use offset rods. Pistons pushing on rods off center from the rod? I am not familiar with any engine that has this design....
__________________
Rich Biebel S/C 1479 Stock 147R |
|
|
|
|
Threaded Mode