camshaft change

Mike Taylor 3601 · 10-10-2012, 10:23 AM

Stand height is correct now? adjusters can be adjusted from bottomed against rocker to 2 turns out,if you can adjust valves with adjusters in that range then your pushrods will work if not then you'll need different length.
If you are'nt sure about stand height I would check using tool Jesel used to supply with rocker kit,it is usaully close.

You can measure base circle on cams to compare.
Mike Taylor3601

10-10-2012, 10:23 AM	#3
Mike Taylor 3601 VIP Member Join Date: Oct 2008 Location: Somerset,Ky Posts: 1,374 Likes: 359 Liked 308 Times in 103 Posts	Re: camshaft change Stand height is correct now? adjusters can be adjusted from bottomed against rocker to 2 turns out,if you can adjust valves with adjusters in that range then your pushrods will work if not then you'll need different length. If you are'nt sure about stand height I would check using tool Jesel used to supply with rocker kit,it is usaully close. You can measure base circle on cams to compare. Mike Taylor3601

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode