|
|
08-14-2019, 05:07 PM | #1 |
Senior Member
Join Date: Jun 2002
Location: Southern California
Posts: 558
Likes: 25
Liked 53 Times in 17 Posts
|
'98 LT1 Firebird Stocker/ SS/GT
This is my white car for sale. IT'S ON SALE !! I am retired from drag Racing.
Car runs as a ’98 with the LT1 since the racecar conversion and body update, it has 20.5 miles on the odometer, it's been a race care it's whole life. It's a natural C/SA car at 3390# or SS/JA at 3235#. Since it has a ram-air hood it fits a bunch of other classes,it would make an excellent SS GT. It’s a very versatile combination. RWR, Rick Watters/Tibor Kadar motor. Bowtie block, small ring package, all the best stuff from a few years ago. Dawson/Hooker headers MSD HSV coil and wires MSD crank trigger MSD distributor with cam sync sensor. Complete Aeromotive fuel system, regulator, A1000 pump, w/fuel filter aft and a strainer and nylon braided hoses (no rubber), fuel pressure sensor CSR water pump Autometer playback Tach, and shift-light Autometer gauges, H20 temp, oil pressure, volts, trans temp. MSD Digital 6 ignition, hand release and pedal release two step with dash activation light Holley HP ECU, with a spare, sequential injection, datalogging with O2 sensing. My program Munsinger converter gone through by A-1 Hurst Pistol Grip shifter Bulletproof ProTrans transmission, manual shift, deep alum pan and mated to an SFI bellhousing, 2.63 1st. Aluminum drive shaft Fuel cell and rear Optima battery, weight box Complete Mark Williams rear, 4.88 gears, gun-drilled 35 spline, aluminum spool with special drum brakes, aluminum drums and soft linings. Latest gen Lamb front brakes with S10 master, the rod cannot fall out! S&W rear anti-roll bar S&W Chrome-moly tubular rear trailing arms optimized for wheelbase. Custom chrome-moly torque arm with special front mount QA1 alum. Adjustable shocks front and rear. ( Penske set available) Mickey Thompson rims front and rear MT fronts and bias rears, radials mounted on Centerline warriors, spare front mounted on Warrior Chrome-moly Roll Bar Turnkey----$xxxxx.00, I’m open to reasonable offers. I have a pretty extensive spare parts inventory that will sell separately or together. Ph. 951 686 4230, bonzaproducts@att.net
__________________
Bernie Cunningham 7053 STK |
|
|