|
![]() |
#1 |
Member
Join Date: May 2009
Posts: 148
Likes: 4
Liked 10 Times in 6 Posts
|
![]()
I'm looking for a switch panel that fits the hole in the factory center trim panel where the heater controls were installed. Does anyone know one that works reasonably well? Thanks for any help.
|
![]() |
![]() |
![]() |
#2 |
Member
Join Date: May 2006
Location: Southwest Florida
Posts: 263
Likes: 35
Liked 43 Times in 29 Posts
|
![]()
Dana I fabricated my own switch panel for my 68 Camaro. I used a piece of aluminum stock and mounted it where the radio was installed, I used a nut and bolt with a large fender washer, it was secured through the hole for the on-off knob and the tunning knob. It is very simple and very neat.
__________________
Mark Ruset 2048 STK |
![]() |
![]() |
![]() |
#3 |
Junior Member
Join Date: Oct 2007
Posts: 10
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
So you don't have to have the factory pannel in there with the heater controls or is this not a stock/SS car?
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Feb 2009
Posts: 967
Likes: 419
Liked 200 Times in 91 Posts
|
![]()
we ran the ARC (autorod.net) #3100 right in '67 camaro heater control panel. worked/fit/looked great...nice piece and racer friendly.
|
![]() |
![]() |
![]() |
|
|