|
![]() |
#1 |
Junior Member
Join Date: Dec 2002
Location: Kalamazoo Michigan
Posts: 34
Likes: 2
Liked 5 Times in 4 Posts
|
![]()
Hey guys I am building a new car, and need to know about the rule for sealing off the trunk area. If I run a moroso sealed battery box, and vent it outside the trunk area, do I also have to run the steel or aluminum plate between the trunk and rear seat, or is just the sealed box legal?
thanks, Kirk |
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Jun 2006
Posts: 3,416
Likes: 522
Liked 330 Times in 178 Posts
|
![]()
No!!!
|
![]() |
![]() |
![]() |
#3 |
VIP Member
Join Date: Jun 2006
Posts: 3,416
Likes: 522
Liked 330 Times in 178 Posts
|
![]()
Actually first ? NO--Second ? YES---Sorry to confuse you---Just remember to follow NHRA rules regarding fastening the box to the gtrunk floor---Comp 387
|
![]() |
![]() |
![]() |
#4 |
Senior Member
|
![]()
Are you planning on using a fuel cell? If so, you will need to seal off the trunk from the driver area.
__________________
Joe Martens AA/Stock 3969 |
![]() |
![]() |
![]() |
#5 |
Junior Member
Join Date: Dec 2002
Location: Kalamazoo Michigan
Posts: 34
Likes: 2
Liked 5 Times in 4 Posts
|
![]()
sorry about that guys, I am running the stock gas tank.
kirk |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Sep 2007
Location: Henderson, NV
Posts: 583
Likes: 8
Liked 54 Times in 27 Posts
|
![]()
The rules state that if you RELOCATE the battery to the trunk, you need a cut off switch. What if the battery originally came in the trunk from the factory? Can NHRA require adding the cabling and switch to a STOCK setup?
|
![]() |
![]() |
![]() |
#7 |
Member
Join Date: Jun 2002
Location: York, PA
Posts: 241
Likes: 0
Liked 1 Time in 1 Post
|
![]()
Master Cutoff Mandatory on all cars with battery in trunk, see rulebook pg 144 under "Electrical"
__________________
Bill Belden Retired Stock Eliminator [emailSTK1100@comcast.net[/email] |
![]() |
![]() |
![]() |
#8 |
Junior Member
Join Date: Dec 2002
Location: Kalamazoo Michigan
Posts: 34
Likes: 2
Liked 5 Times in 4 Posts
|
![]()
thanks for the help guys, I was given some wrong info from someone else,and I wanted to make sure i didn't have to do both. I already have the master cutoff switch mounted, so i should be good to go with the moroso box.
thanks again, Kirk |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|