Jerico Question

Don Fardie · 04-18-2008, 09:35 PM

Has anyone had to replace the bushing that is in the tail section of a DR-4. When installing my driveshaft today I noticed it was binding the farther I pushed it in to gain access to set the rear U-Joints. I ended up removing the tail section and noticed the bushing was wiped. I have a good idea what may have caused it, but not sure in which direction the bushing is removed. Doesn?t look as if there is a lip at either end and it seems as if it is just press fitted like the T-10?s are. Just want to make sure before I break out the tools.
Any help is appreciated???Don

04-18-2008, 09:35 PM	#1
Don Fardie Member Join Date: Feb 2003 Location: Lakeville, Ma Posts: 253 Likes: 0 Liked 0 Times in 0 Posts	Jerico Question Has anyone had to replace the bushing that is in the tail section of a DR-4. When installing my driveshaft today I noticed it was binding the farther I pushed it in to gain access to set the rear U-Joints. I ended up removing the tail section and noticed the bushing was wiped. I have a good idea what may have caused it, but not sure in which direction the bushing is removed. Doesn?t look as if there is a lip at either end and it seems as if it is just press fitted like the T-10?s are. Just want to make sure before I break out the tools. Any help is appreciated???Don __________________ Don Fardie 1582 F/S B/G

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode