Low travel hydraulic stocker lifters

Bill Bogues · 07-17-2013, 09:26 PM

Ineed some input on the "best' or the right way to adjust these things. I'm not sure about the way they "feel" or the noise they make when I adjust them. bye the way, they are Trend lifters for a small block chevy. Any Input will be appreciated.

G Anderson · 07-18-2013, 09:07 PM

Only have had these for 3 yrs-But this is how I've been doing it--------
I push down on the back side of the rocker with my finger while sliding a .015 feeler gauge between the rocker and the valve and adjust lock nut for the "feel" that I like ! Sooner or later I will try setting them looser or tighter ?

Mike Taylor 3601 · 07-19-2013, 08:14 AM

G Anderson,
That is the same method I use.
I say if you tighten your lash to .003 or .005 you'll see and improvement.

I use the in closing/ex opening (honda method)in case need explanation,intake is almost closed set the ex ex barely opens set the intake if engine is warm usaully start with setting ex valves,if you go through all ex or all in engine does'nt have to rotate alot if rotating by hand just make sure you rotate engine the direction it runs.
Mike Taylor 3601

jmcarter · 07-19-2013, 12:58 PM

Quote:

Originally Posted by Mike Taylor 3601

G Anderson,
That is the same method I use.
I say if you tighten your lash to .003 or .005 you'll see and improvement.

I use the in closing/ex opening (honda method)in case need explanation,intake is almost closed set the ex ex barely opens set the intake if engine is warm usaully start with setting ex valves,if you go through all ex or all in engine does'nt have to rotate alot if rotating by hand just make sure you rotate engine the direction it runs.
Mike Taylor 3601

Bingo!

07-17-2013, 09:26 PM	#1
Bill Bogues Member Join Date: Apr 2005 Location: Bethany La. Posts: 323 Likes: 96 Liked 169 Times in 53 Posts	Low travel hydraulic stocker lifters Ineed some input on the "best' or the right way to adjust these things. I'm not sure about the way they "feel" or the noise they make when I adjust them. bye the way, they are Trend lifters for a small block chevy. Any Input will be appreciated. __________________ Bill Bogues 4696 STK

07-18-2013, 09:07 PM	#2
G Anderson Member Join Date: Dec 2009 Location: Iowa Posts: 105 Likes: 13 Liked 4 Times in 3 Posts	Re: Low travel hydraulic stocker lifters Only have had these for 3 yrs-But this is how I've been doing it-------- I push down on the back side of the rocker with my finger while sliding a .015 feeler gauge between the rocker and the valve and adjust lock nut for the "feel" that I like ! Sooner or later I will try setting them looser or tighter ?

07-19-2013, 08:14 AM	#3
Mike Taylor 3601 VIP Member Join Date: Oct 2008 Location: Somerset,Ky Posts: 1,371 Likes: 352 Liked 304 Times in 102 Posts	Re: Low travel hydraulic stocker lifters G Anderson, That is the same method I use. I say if you tighten your lash to .003 or .005 you'll see and improvement. I use the in closing/ex opening (honda method)in case need explanation,intake is almost closed set the ex ex barely opens set the intake if engine is warm usaully start with setting ex valves,if you go through all ex or all in engine does'nt have to rotate alot if rotating by hand just make sure you rotate engine the direction it runs. Mike Taylor 3601