HOME FORUM RULES CONTACT
     
   
   

Go Back   CLASS RACER FORUM > Class Racer Forums > Stock and Super Stock Tech

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-25-2012, 08:02 PM   #1
Philip Saran
Senior Member
 
Join Date: Oct 2006
Location: Parker, CO.
Posts: 728
Likes: 165
Liked 14 Times in 11 Posts
Default Wiring question?

When running the motor, if I turn off at the kill switch everything goes dead
like it is supposed to, BUT if I shut it down from inside the car (has a Taylor
switch panel) car does not shut down until it runs out of gas (1/2" fuel line)
after I turn off the electric pump.

Only item that is not wired to the kill switch is the altenator, that wire is run
across the firewall to the big wire on the starter.

What am I doing wrong?

## I just talked with Randy Loge and he set me straight in that I have the red wire
for the MSD going back to the kill switch big lug (opposite side from the battery)
and I should have it going to the ignition switch on the Taylor switch panel.##

I am also considering removing the Taylor switch panel and go back to the
ignition key start and just two toggle switch's for the fuel pump and fans

So now I know what I should do to fix this, but I am still open to all comments &
suggestions, I do not like shutting down the motor the way it is.
__________________
Phil Saran
Parker, Colorado

Last edited by Philip Saran; 07-25-2012 at 08:17 PM.
Philip Saran is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.