|
|
|
|
05-06-2012, 01:24 AM
|
#1 |
|
Member
Join Date: Jul 2009
Location: Bulington, Ky
Posts: 359
Likes: 0
Liked 6 Times in 5 Posts
|
engine help?
went racing last night and car run fine until 3rd rd. got in car fired it up and it sounded bad and idle hi with out touching the gas. turned it off and toke off valve cover and with some of the push rods you could move them up and down. rejusted valves and still got loose. thanks.
|
|
|
|
05-06-2012, 06:48 AM
|
#2 |
|
Junior Member
Join Date: Feb 2012
Location: new jersey
Posts: 3
Likes: 0
Liked 0 Times in 0 Posts
|
Re: engine help?
sounds like a lobe on the cam or lifter went.
|
|
|
|
|
05-06-2012, 09:24 AM
|
#3 |
|
VIP Member
Join Date: Jun 2002
Location: New Holland, PA Mooresville,NC
Posts: 1,163
Likes: 238
Liked 16 Times in 11 Posts
|
Re: engine help?
Drain oil and look for Stuff in the oil, sounds like wipped lobes. If junk in oil take apart the whole engine, everything will have to be gone over, make sure you get the block cleaned out, cam stuff will be deep in oil galleys.
__________________
Bob Pagano A/SA |
|
|
|
|
05-06-2012, 09:57 AM
|
#4 |
|
Member
Join Date: Jul 2009
Location: Bulington, Ky
Posts: 359
Likes: 0
Liked 6 Times in 5 Posts
|
Re: engine help?
If it is lobes on cam what could have cause that?? Or lifters go bad?? Motor haves 155 passes on it. Thanks.
|
|
|
|
|
05-06-2012, 10:13 AM
|
#5 |
|
Junior Member
Join Date: Feb 2012
Location: new jersey
Posts: 3
Likes: 0
Liked 0 Times in 0 Posts
|
Re: engine help?
could be wrong spring pressure or the type of oil you are using.
|
|
|
|
|
05-06-2012, 10:19 AM
|
#6 |
|
Junior Member
Join Date: Feb 2012
Location: new jersey
Posts: 3
Likes: 0
Liked 0 Times in 0 Posts
|
Re: engine help?
i should ask you what type of cam you running solid hydr or roller
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
