View Single Post
Old 12-13-2017, 04:28 PM   #10
Paul Precht
Senior Member
 
Paul Precht's Avatar
 
Join Date: Dec 2001
Location: Elysburg, Pa
Posts: 689
Likes: 279
Liked 223 Times in 88 Posts
Default Re: Aftermarket/Replacement Cylinder Head Rule Change

I could be wrong but I don't think it is practical to use the Edelbrock head on the Max Wedge, the port mismatch would be quite a challenge since you cant enlarge the ports. If they raise the iron head HP to the aluminum head HP the factor would be higher than the original.
Paul Precht is offline   Reply With Quote