View Single Post
Old 07-13-2017, 03:32 PM   #6
63corvette
Senior Member
 
Join Date: Mar 2007
Location: Canyon, Tx
Posts: 534
Likes: 117
Liked 279 Times in 87 Posts
Default Re: Trailer Wheel Bearing Issue

Quote:
Originally Posted by Bobby DiDomenico View Post
Rick,
I'm not familiar with these, is there an inner and outer bearing?
If so, when you replaced the outer did you replace the inner bearing assembly as well? IIRC if the inner one is somewhat loose might it cause the outer one to move and have cage failure?
I hate roadside repairs!
It is a 8,000 Dexter axle with a larger inner bearing and a smaller outer bearing.
Both bearings and hub replaced each time.

One thing Dexter recommends is to torque the bearings to 125 ft lbs before backing them out and setting them with only finger tight and backed off to get the nut lock in place.
Basically zero slack in the bearings cold.
I have not seen this in black and white just the recommendation from one of the reps.
I have always set mine close to a flat on the nut loose once snugged up with a pair of channel locks for the last 40 to 50 years.
Yes I am old.
Thanks for the input.
Rick
63corvette is offline   Reply With Quote