CLASS RACER FORUM - View Single Post

Stewart Way · 08-22-2019, 07:16 PM

EDM on the roller bearing would give me a 60mm journal. Don't know the life expectancy of roller bearings either but won't have a lot of spring load. May find a 60mm blank but I tried 65mm for the regular bearing and no luck. High HP performance said that cam spacers in the past were $1500. This is the block we talked about in the past. The Bryant crank is cut to LS main size for the regular type thrust bearing. 2.95 stroke for 305 inch so usless for anything serious. Carillo rods at 6.5" and honda rod bearings. Don't have much in it but hate to make a coffee table out of it. Maybe later for a project.

08-22-2019, 07:16 PM	#3
Stewart Way Member Join Date: Aug 2003 Location: Atlanta Posts: 475 Likes: 15 Liked 70 Times in 21 Posts	Re: Gen 3 hemi cam bearing spacers EDM on the roller bearing would give me a 60mm journal. Don't know the life expectancy of roller bearings either but won't have a lot of spring load. May find a 60mm blank but I tried 65mm for the regular bearing and no luck. High HP performance said that cam spacers in the past were $1500. This is the block we talked about in the past. The Bryant crank is cut to LS main size for the regular type thrust bearing. 2.95 stroke for 305 inch so usless for anything serious. Carillo rods at 6.5" and honda rod bearings. Don't have much in it but hate to make a coffee table out of it. Maybe later for a project. __________________ Stewart Way 2424 SS