CLASS RACER FORUM - View Single Post

Run to Rund · 03-13-2019, 10:32 AM

I have had to use offset dowels and also correct in and out being off square. I use Lakewood dowels drilled and tapped 5/16 x 18 so I can remove them with a slide hammer. I have gotten some pretty bad alignments to within .001" by carefully orienting the dowels. Yes, I also have found QT to be much better than the old Lakewoods, but still the block is often not close enough.

03-13-2019, 10:32 AM	#7
Run to Rund Senior Member Join Date: Sep 2007 Posts: 574 Likes: 6 Liked 44 Times in 22 Posts	Re: bellhoushing I have had to use offset dowels and also correct in and out being off square. I use Lakewood dowels drilled and tapped 5/16 x 18 so I can remove them with a slide hammer. I have gotten some pretty bad alignments to within .001" by carefully orienting the dowels. Yes, I also have found QT to be much better than the old Lakewoods, but still the block is often not close enough.