Re: 75 Nova U/SA
Modified a JEGS universal fit drive shaft loop, cut one of the loops down and redrilled holes, shortened the L mounts. Reused the cutoff pieces by tack welding bolts in them so can put these inside the car and can 'one man' mount the loop from the underside. Cleaned/painted the underside of car. The rearend is 8.5 ten bolt with top Moser stuff and 5.14 gear, all new brake parts. Lucked out finding a housing with single leaf pads. Refurbed the used core support, welded patches where needed, sand blasted, naval jelly, rustoleum. The rear mounted with energy suspension pads, spring bushings, and eventually stock spring shackles. Comp engineering adjustable shocks set on 50/50, the comp engineering traction bars are a Craigslist score for $125 complete. Drivers side floor pan patched (I fabricated, took the replacement panel back) rest of the floor good. Also did a test fit on the slicks-a used goodyear radial and a M/T I got in the throwaway pile at Charlotte. No interference anywhere.
Behind the core support is a used Sepanek metric 200 and PTC converter I found on Craigslist for $600 total. Also some weld wheels for $250 total (all four). Not pictured are Goodyear front skinnes for $75, and Hoosier 28x9 bias almost new for $100 from Craigslist.
__________________
Mike Moller
NHRA 203 Q-R-T/SA
Last edited by MikeMoller; 01-23-2015 at 02:27 PM.
Reason: add
|