CLASS RACER FORUM - View Single Post

FLEMING · 09-13-2013, 09:48 AM

I did buy stock upper control arm bushings and machine the "teeth" off the ends of them, then took brake cylinder hone and honed the inside of the bushing so that it slid on and off the shaft easily, then greased them really good, I used the moog kit with the offset upper shafts.. It was really free moving after I tightened everything up and saves you a ton of money.. if you look on alot of the good working stockers alot of them are this way..

09-13-2013, 09:48 AM	#15
FLEMING Member Join Date: Aug 2003 Posts: 238 Likes: 19 Liked 21 Times in 11 Posts	Re: Front End Suspension, NHRA Rule Question I did buy stock upper control arm bushings and machine the "teeth" off the ends of them, then took brake cylinder hone and honed the inside of the bushing so that it slid on and off the shaft easily, then greased them really good, I used the moog kit with the offset upper shafts.. It was really free moving after I tightened everything up and saves you a ton of money.. if you look on alot of the good working stockers alot of them are this way..