The front lower lip of the wheel well opening was opened up. The lower plastic rocker panel covers also need to be cut, sectioned and plastic welded back together in order to fit the modified wheel openings.
Here is the lower plastic rocker pnael after being modified and refinished. Thanks to Adrian from Varsity Ford.
Fabrication of seat mount frame.
Seat moch up. After trying out this mount I will use it on the passenger side and fabricate a driver side mount that is higher in the back. As shown the seat leans back too much for my comfort.
The body is now at the paint shop. The body will be painted Sonic Blue.
My throttle body cam back from Accufab this week. The drive by wire stepper motor was removed and a manual linkage mechanism was attached to the throttle blade shaft.