10-24-2018, 09:03 PM
|
#30
|
Senior Member
Join Date: Jun 2011
Location: Ga.
Posts: 521
Likes: 7
Liked 13 Times in 11 Posts
|
Re: Turbo 400 experts please step in....
Quote:
Originally Posted by Mark Ugrich
You are partly correct. The tube was necked down to locate it to the fittings. This allowed for just a straight short piece of rubber vacuum line to seal the connection. If you look closely into the opening of the tube, you will most likely see a restriction on the end by the modulator. I would open up the ends of the metal line with a drill of appropriate size.It’s possible you may have to change the 1-2 shift valve spring in the valve body to get the trans to shift where you want it to.
|
Thanks.
|
|
|