CLASS RACER FORUM - View Single Post - Looking for a Holley Terminator X wiring expert.

Cglrcng · 01-23-2025, 10:25 PM

Well crap...MSD makes a simple $129 buck ($140 w/tax), Part # 8509 Module that converts the V sine signal of a magnetic p.u. to a square wave signal that works with either the white points output wire of an MSD Ign. Box or will work w/the crank/cam signal wires.

Ordered it last night so it can easily be installed by next week's test day, and bracket races 1&2. While I was out searching for the best solution it was available on the Holley website all along.

At least I am getting the conversion time between old and new systems down to about 2.5 hrs or less. That could help in a pinch. And I am learning.

01-23-2025, 10:25 PM	#27
Cglrcng Member Join Date: Aug 2023 Location: Kingman, AZ Posts: 393 Likes: 1,376 Liked 308 Times in 176 Posts	Re: Looking for a Holley Terminator X wiring expert. Well crap...MSD makes a simple $129 buck ($140 w/tax), Part # 8509 Module that converts the V sine signal of a magnetic p.u. to a square wave signal that works with either the white points output wire of an MSD Ign. Box or will work w/the crank/cam signal wires. Ordered it last night so it can easily be installed by next week's test day, and bracket races 1&2. While I was out searching for the best solution it was available on the Holley website all along. At least I am getting the conversion time between old and new systems down to about 2.5 hrs or less. That could help in a pinch. And I am learning. __________________ Gary Lucier - 7832 STK. / 7832 E.T. EF/S Slow Sled. I am, but a simple test of your true patience. So, do all the really "Big Wheelies" you can!