CLASS RACER FORUM - View Single Post - drilling cragar super tricks for a 5/8'' stud

MAURICE BLENDHEIM · 11-23-2023, 02:08 AM

Ron… I have several sets of Super Tricks, Centrelines, Weld Wheels they all accept a Standard Mag wheel lug nut which measures .6875". I have new sets of MOROSO and Mark Williams 5/8"(.625") Studs that all measure .6875" on the shank. The description 5/8"(.625) is the thread diameter of the Retaining Nuts to the Axle and the Wheel Retaining Nuts. If your axles have a press in stud, you most likely will have to drill the flange to accept the .625 stud. In theory you should be "good to go". Hope this helps you…Maurice.

11-23-2023, 02:08 AM	#3
MAURICE BLENDHEIM Senior Member Join Date: Jun 2011 Location: Langley (no igloos), British Columbia, Canada Posts: 566 Likes: 305 Liked 264 Times in 85 Posts	Re: drilling cragar super tricks for a 5/8'' stud Ron… I have several sets of Super Tricks, Centrelines, Weld Wheels they all accept a Standard Mag wheel lug nut which measures .6875". I have new sets of MOROSO and Mark Williams 5/8"(.625") Studs that all measure .6875" on the shank. The description 5/8"(.625) is the thread diameter of the Retaining Nuts to the Axle and the Wheel Retaining Nuts. If your axles have a press in stud, you most likely will have to drill the flange to accept the .625 stud. In theory you should be "good to go". Hope this helps you…Maurice. Last edited by MAURICE BLENDHEIM; 11-23-2023 at 02:11 AM.