View Single Post
Old 05-26-2020, 12:40 PM   #2
Rory McNeil
VIP Member
 
Join Date: Jun 2007
Location: from Vancouver BC Canada, now in Nova Scotia
Posts: 1,311
Likes: 317
Liked 1,105 Times in 303 Posts
Default Re: Jerico Setup in 1995 Mustang

My Mustang was a 85, but I used the factory style cable clutch setup, and a McLeod Soft Lok unit, 10" diameter. It is my understanding that the 94-5 Mustangs had a 1" longer input shaft, and deeper bellhousing, don`t know if the Jerico and scattershield need to be like that, or if the earlier FOX stup will fit. I can say that a deeper bell would be nice, as the packaging with the clutch fork, and Long style pressure plate required the special thin, cut down clutch fork, adjustable throwout bearing, and an adjustable pivot ball stud. Even still ,it`s very tight in there. I had both the FOX Lakewood and McLeod scattershields in my Mustang, with my Flowtech headers, the McLeod fit perfectly, the Lakewood hit the headers, but not too severely.
__________________
NHRA 6390 STK
M/S 85 Mustang
Rory McNeil is offline   Reply With Quote
Liked