CLASS RACER FORUM - View Single Post

Eman · 03-23-2018, 11:59 AM

Is the lower part the bolt goes through a piece of square aluminum tubing? And then the angle brackets welded together over the top of that?
I don't know about legal, but I would make my seat brackets out of steel with that much braketry. I would think the square aluminum tubing would want to crush when tightened. Are these plastic seats?

03-23-2018, 11:59 AM	#5
Eman Member Join Date: May 2014 Location: E TN Posts: 473 Likes: 16 Liked 133 Times in 76 Posts	Re: seat bracket Is the lower part the bolt goes through a piece of square aluminum tubing? And then the angle brackets welded together over the top of that? I don't know about legal, but I would make my seat brackets out of steel with that much braketry. I would think the square aluminum tubing would want to crush when tightened. Are these plastic seats?