CLASS RACER FORUM - View Single Post

Greg West · 01-07-2017, 07:42 PM

I have modified the pivot ball I have so I can adjust it in and out. With the pivot ball that came with the Quick Time, the fork is up tight against the pressure plate. I did compare the distance from the engine face to the trans face of the Quick Time bellhousing and an old Lakewood housing that I have. The Quick Time is .068" shorter than the Lakewood. This measurement includes the difference in thickness of the respective engine plates for each bellhousing.

01-07-2017, 07:42 PM	#4
Greg West Junior Member Join Date: Jul 2016 Posts: 63 Likes: 26 Liked 52 Times in 22 Posts	Re: Clutch Fork/Bellhousing Interference I have modified the pivot ball I have so I can adjust it in and out. With the pivot ball that came with the Quick Time, the fork is up tight against the pressure plate. I did compare the distance from the engine face to the trans face of the Quick Time bellhousing and an old Lakewood housing that I have. The Quick Time is .068" shorter than the Lakewood. This measurement includes the difference in thickness of the respective engine plates for each bellhousing.