CLASS RACER FORUM - View Single Post

Eman · 06-16-2016, 06:35 PM

Mine were stripped out, not loose. I just drilled and retapped what was there. Loose isn't a problem as they will tighten up when the bolt tightens. If I have any furthur problems all I would do is drill a hole in the side of the sheetmetal frame member and use a nut inside. There isn't much pressure on those bolts.

06-16-2016, 06:35 PM	#14
Eman Member Join Date: May 2014 Location: E TN Posts: 473 Likes: 16 Liked 133 Times in 76 Posts	Re: Trans Bolt Holes 3rd Gen Camaro Mine were stripped out, not loose. I just drilled and retapped what was there. Loose isn't a problem as they will tighten up when the bolt tightens. If I have any furthur problems all I would do is drill a hole in the side of the sheetmetal frame member and use a nut inside. There isn't much pressure on those bolts.