Quote:
Originally Posted by MEXJOE
I am looking for ideas on how to make the Santhuff front shocks work on a 69 Camaro.
I have looked at the Rinehart set up but I don't have the longer shocks required for that setup.
I had them in the car but had to disassemble the frontend to install them.
I am trying to find an A-ARM (stock) that has a big enough hole to fit the shock through. Thanks!
|
I run the Santhuff's DA's on my 68 camaro. But AFCO makes a GM style weld-in lower shock mount, speedway sells it part# A550090108X, only about $10 each for this application. you cut a hole in your stock lower control arm and weld this in. It also works with the AFCO shocks as well. Actually, the AFCO shocks mount better as the adjustment knob is on the bottom of the shock and comes out below the hole for easy adjustment. The Santuff's are tucked up inside, I have to take them loose at the bottom and pull my shocks down thru the hole to gain access to the adjustment knob which is on the side of the shock. I wish Santuff would change that design. I also talked to Marty's about his setup but you have to have the longer shocks to go through the bottom of the a-frame and mount below it, but it does makes easy access to the adjustment knob if you have to change it a lot. But once mine were set I leave them alone..