CLASS RACER FORUM - View Single Post

FED 387 · 03-12-2015, 05:35 PM

Check the control arm bushings too -- make sure you can pivot them without the springs and shocks with about 5 POUNDS resistance-----open em up in the bore so that there is almost no resistance when they pivot--- also cut a minute amount off the snubber on the upper arms too ----if it helps cut a little more off--- keep doing this until you see no more improvement then leave em alone---your problem it seems is after the front end has risen it is not coming back down---- now you will hafta figure why its not coming down something is keeping it up WHAT???-- FED 387

03-12-2015, 05:35 PM	#9
FED 387 VIP Member Join Date: Jun 2006 Posts: 3,420 Likes: 529 Liked 333 Times in 180 Posts	Re: Front end rise Check the control arm bushings too -- make sure you can pivot them without the springs and shocks with about 5 POUNDS resistance-----open em up in the bore so that there is almost no resistance when they pivot--- also cut a minute amount off the snubber on the upper arms too ----if it helps cut a little more off--- keep doing this until you see no more improvement then leave em alone---your problem it seems is after the front end has risen it is not coming back down---- now you will hafta figure why its not coming down something is keeping it up WHAT???-- FED 387