[buzzinhalfdozen]

Larry, if you already have the means to bend the tubing I'd suggest you bend your own. I've installed quite a few "kits" none of which fit exactly as I'd have liked, the only way to gain experience is to practice. Yes you'll prolly scrap a few pieces but you'll learn alot. I've used a couple different software programs over the years that have really helped mainly when trying to make a bar that requires rotating in the die (like a one piece A pillar bar) of course math is not my strong suit so the software really helped me. I can almost walk the pits and point out the "kit" cages , as someone else stated there are a few options in design , I prefer the continuos A pillar set up it takes more fitting up and time but gives (I think) the most room in the vehicle. Good luck with what ever you decide. Joe