[Dragsinger]

some suggestions;

*mix 50/50 ATF and Acetone

*use a propane torch keeping the flame a few inches from the wheel, heat all around stud/wheel flange area. Use judgement about how much heat and for how long. Maybe 45 seconds, 60 seconds.

*use a squirt gun to apply 50/50 mix the the studs

*let it soak and cool, possibly repeat the process.

*if a rubber mallet will not loosen try putting the lug nuts on a few rounds, set car on ground
and rock car side to side.

*Take two aspirin and post results in the morning