Quote:
Originally Posted by Dwight Southerland
Yes, you can. You will have to use MW housing ends for large axle bearings. Call MW and tell them what you are doing.
|
Agreed. I have Mark Williams 35 spline axles (no drilled) in a 12 bolt which has been in service since the mid 90's. All the internal parts are holding up extremely well and have not replaced anything other than gear sets for tweaking of ratios with combination changes.
The MW captured bearing housing ends are really nice as well.
11/16" drive studs, billet caps and a girdle cover should be on the parts order list as well.