Quote:
Originally Posted by Bill Diehl
Valve seats.....when installing new seats can you blend in the ridge in the casting at the bottom of the seat?
Is the Quick Fuel SSR-780-VS an acceptable replacement for the D0ZF 9310-Z Holley 4653?
Can an adjuster be installed on the pushrod side of the rocker arm
Can floor mounted clutch linkage be installed?
Can the block be machined for 42/46 lifter phasing?
Thanks
|
anybody?
The way I read the rules the carb is the same size so should be ok.
One more question....
Is a carb spacer legal?