View Single Post
Old 07-29-2013, 04:24 PM   #3
Tgreen3724
Junior Member
 
Join Date: Oct 2007
Location: Shepherdsville, Ky
Posts: 38
Likes: 0
Liked 1 Time in 1 Post
Default Re: Help wiring pressure switch,line lock and 2-step

Ive posted very similiar questions here on classracer. What I ended up trying was using a two step button with no transbrake. Basically I stage with engine rev'd 500 or so short of 2 step limiter. Once the stage is on i go WOT then just let go of the button when you want to leave. The foot comes off the break on its own. I really wasnt sure if this would work or not before i tried it and let me say it works great. First shot out i was .050, adjusted my button went .036, then .019, then .039, over the course of three time runs and four rounds my lights were all green and between 0.019-0.056. I plan to raise the two step up about 400 rpm next time that should take about 0.014 out of the Vehicle Reaction time and put me 0.005 - 0.042. Of course im no expert and different things work for different people. Just my thoughts.

I wouldnt tie it into the line loc but thats me
Tgreen3724 is offline   Reply With Quote