[Rory McNeil]

Well, it is pretty consistent, and in 12 years, the only real breakage has been knocking a few teeth off 3rd gear a few years ago. I need to pull the trans to fix an oil leak, so I guess I will remove the counterweight at that time. I never really used any counterweight before this clutch freshen up. My tach is a playback model, but it has no provisions for driveshaft RPM. I`d really be suprised if I have "way too much" clutch static though, as when I do encounter flare up on the 3-4, or noticable slippage in 4th, I can normally cure the slippage with 1/2 turn increase of static. And as I mentioned in the first post, rolling on the throttle on the return road at 2500-3000RPM will result in noticable slipping. I do normally shift it clutchless. One other thing I should add, don`t know if its really relevent or not, but Hyatt did the last clutch rebuild, and instead of the normal .280" disc McLeod supplies, Tim uses a .380" thick disc, and I have the pressure plate shimmed up .100" to compensate for the added thickness. And lastly Kris, since you also run a FE, have you had any issues with the pilot bearing "falling out" of the crankshaft? I use the ball bearing pilot, and it kinda sticks out of the crank a ways, and is not a very tight press fit, and has been found just sitting on the input shaft a couple of times . I last installed the pilot bearing with red Loctite, I`ll take a look when I pull the trans out in the near future.