CLASS RACER FORUM - View Single Post

Michael K · 11-10-2012, 07:50 PM

I used Moog ball joints on my 68 A-Body that has 73-76 front suspension.

The paperwork Moog supplied said "thread ball joint squarely into control arm until shoulder of ball joint is firmly seated against the arm. If torque required to seat the housing is less than 125 ft-lbs, the control arm must be replaced."

I can't remember what mine checked at, but well over 125 ft-lbs.

11-10-2012, 07:50 PM	#14
Michael K Member Join Date: Nov 2012 Location: Minnesota Posts: 101 Likes: 89 Liked 62 Times in 17 Posts	Re: Mopar Ball Joints I used Moog ball joints on my 68 A-Body that has 73-76 front suspension. The paperwork Moog supplied said "thread ball joint squarely into control arm until shoulder of ball joint is firmly seated against the arm. If torque required to seat the housing is less than 125 ft-lbs, the control arm must be replaced." I can't remember what mine checked at, but well over 125 ft-lbs.