CLASS RACER FORUM - View Single Post

rod · 09-19-2012, 06:31 PM

for this 327, i am going to cut the pin bore for double Tru-Arc lock rings [each side naturally] the lock rings are .042" wide.
what i do not know is how much extra width to make the groove.
any help is always greatly appreciated.
rod in AZ

09-19-2012, 06:31 PM	#1
rod Member Join Date: Dec 2009 Location: Kingman, NW AZ. in the middle of the longest stretch of Route 66 Posts: 314 Likes: 0 Liked 20 Times in 15 Posts	pin lock ? for this 327, i am going to cut the pin bore for double Tru-Arc lock rings [each side naturally] the lock rings are .042" wide. what i do not know is how much extra width to make the groove. any help is always greatly appreciated. rod in AZ