Quote:
Originally Posted by Mark Yacavone
Guys, I've modified plenty of stock seats to where they would still pass tech.
I've taken every other spring out of back seats to lighten then , and I've cut a slot into a driver's high back bucket for a Y- harness to pass through, then padded the slot and had it re-upholstered.
I've welded the adjusters and even the hinge up and I've braced up the seat brackets under the floor board.
I never had a problem needing to get anything approved...Never asked.
So, I would say;
A ,
If you're afraid to race with stock seat, modify the yourself. Of course, they might end up HEAVIER.
Or B,
Get yourself a slower car. You don't see Jody Lang on here complaining about his seats, do you?
|
Not trying to be a *****,but were does it say you can modify your sit.Driver’s seat tracks may be bolted down but you can't do any other modification or it would say you can,so you are not allowed the pull spring to make it lighter
UPHOLSTERY
Must have full factory-type upholstery for year/model claimed,
including factory-type floor mats or carpet, door panels and
headliner, and front and rear seats. Interior gutting prohibited.
Driver’s seat tracks may be bolted down. Sun visors optional. Rear
seat may be removed when roll bar is installed; area must be
carpeted or upholstered equivalent to factory specifications (no
bare paneling). See General Regulations 6:2.
just because it doesn't say you can't doesn't mean you can.
but maybe under this for safety I'm not sure
HOW TO USE THIS RULEBOOK
The NHRA Rulebook provides guidelines and minimum standards
for the construction and operation of vehicles used in NHRA
Championship Drag Racing and at member-track events. It is the
responsibility of the participant to be familiar with the contents of
this Rulebook and to comply with its requirements. Do not leave it
up to track officials to catch all potential rule compliance problems.
That responsibility rests first and foremost with YOU — the
participant.
Additional safety equipment or safety-enhancing equipment is
always permitted and the levels of safety equipment stated in
this Rulebook are minimum prescribed levels for a particular
type of competition and do not prohibit the individual racer
from using additional safety equipment. Participants are
encouraged to investigate the utility of additional safety
devices for your type of competition. In disputed cases,
whether an item of equipment is safety-enhancing or
performance-enhancing will be determined by NHRA in
NHRA’s sole and absolute discretion.
On the other hand, as to performance equipment, it is the
general rule that unless optional performance equipment or
performance-related modification is specifically permitted by
this Rulebook, it is prohibited. All model, engine, or equipment
changes or modifications not specifically addressed in this
Rulebook must be submitted in writing to NHRA for
consideration prior to competition. Approval will be granted or
denied in NHRA’s sole and absolute discretion. The applicant
will be notified of approval or rejection in writing from NHRA
headquarters in Glendora, Calif.
BTW I've done the same mods as you to my own seat.even with the springs