Quote:
Originally Posted by Adger Smith
Art,
What is the Ohms resistance per inch on the wires you are using?
What should the ohms resistance be for wires used with the LS-1 coils??
Are the LS-1 wires a lot shorter than yours?
I think I'm reading your mind on this.
|
Hi Adger. I'm using msd LS1 wires now. They are about 9 inches long each. When I ohm tested them 3 are 28 ohms and one is 26 ohms.
The coils seem to check out fine. A bright blue spark in the coil tester (through the wires).
I just checked the fuel injectors and they are all firing.
I might try to adjust the coil dwell, and see if that makes any difference. But it ran this way for 2 years.
If you are reading my mind now I'm sure you are hearing words you might have never heard. LOL
Here is a picture of the coils and plug wires. I was wondering if the bend they make could have a bad effect on them and not show when they were straight?
