CLASS RACER FORUM - View Single Post

Kegracing · 04-16-2011, 08:40 AM

On my 67 Firebird, I have the tab on back of the roll bar that the sholder straps bolt to, and belts just lay over the top of the seat at headrest area. The lap belts are bolted into the original seat belt locations, and for crotch strap,I welded a piece of 1/4" steel plate to the riser below the front of the seat, about 2" x 3" long, and drilled and tapped it for the seat belt bolt. Used a extra seat belt bolt from pass side. Works well, no cutting of seats, crotch belt does look bad, and all work well, and fit well.

Good luck,

Ken

04-16-2011, 08:40 AM	#5
Kegracing Member Join Date: Jun 2002 Location: Red Oak, TX Posts: 441 Likes: 0 Liked 0 Times in 0 Posts	Re: NHRA Stock seat and belt setup On my 67 Firebird, I have the tab on back of the roll bar that the sholder straps bolt to, and belts just lay over the top of the seat at headrest area. The lap belts are bolted into the original seat belt locations, and for crotch strap,I welded a piece of 1/4" steel plate to the riser below the front of the seat, about 2" x 3" long, and drilled and tapped it for the seat belt bolt. Used a extra seat belt bolt from pass side. Works well, no cutting of seats, crotch belt does look bad, and all work well, and fit well. Good luck, Ken